End of Material Sensor (Electro-mechanical) Sensors When used with Wintriss die

When used with Wintriss die protection controllers

In the "Related Products" section below

50/60 Hz for 1 minute between current-carrying parts and case Vibration resistance Destruction: 10 to 55 Hz

Residual voltage 1 V max

End of Material Sensor (Electro-mechanical) Sensors When used with Wintriss dieThe End of Material sensor is designed for metal stamping applications. It detects material run out, and prevents pulling of the coil end through the feeder or straightener. It also keeps the press from running without coil stock. The sensor is typically installed so that the arm rides on the material. When the material runs out, the arm drops onto the insulated pin below it, generating a ground signal that is detected by the die protection